RFX Race Series OEM Replica Kill Switch

The RFX Race Series circuit breakers are OEM replacement parts.

Complete with the same fittings, fasteners, connectors, and cable lengths as the original part.

Available for a wide variety of motorcycles.

Features:

• OEM replacement
• Accepts all original connectors
• OEM cable length

Assembly instructions:

• Start by removing the front plate.
• Carefully cut the cable ties holding the cables of the start and stop switch on the handlebar, then unscrew the clamps and let them hang.
• Locate the switch connector on the motorcycle, it is often close to the steering column on the chassis but can sometimes be found under the tank.
• Detach the connector and remove the switch noting the wiring path.
• Clean the connector with an electrical contact cleaner.
• Securely attach the new switch to the handlebar in the desired position.
• Route the wires as with the old switch and assemble the connector.
• Check that the wires are not tight by turning the handlebar to full extension, adjust if necessary.
• Reinstall the cable ties if possible by positioning the cables behind the handlebar to avoid damage from debris.
• Put your front plate back in place.