Cut-off switch RFX Race Series - OEM replica

The RFX Race Series circuit breakers are OEM replacement parts.

Complete with the same fittings, fastenings, connectors, and cable lengths as the original part.

Available for a wide variety of bikes.

Features:

• OEM replacement
• Accepts all original connectors
• OEM cable length

Assembly instructions:

• Start by removing the front plate.
• Carefully cut the cable ties holding the cables of the start and stop switch on the handlebars, then unscrew the clamps and let them hang.
• Locate the switch connector on the bike, it is often close to the steering column on the frame but can sometimes be found under the tank.
• Detach the connector and remove the switch noting the wiring path.
• Clean the connector with an electrical contact cleaner.
• Secure the new switch lightly to the handlebars in the desired position.
• Pass the wires as for the old switch and assemble the connector.
• Check that the wires are not tense by turning the handlebars to full extension, adjust if necessary.
• Reinstall the cable ties if possible by positioning the cables at the back of the handlebars to avoid damage from debris.
• Put your front plate back in place.