LAZER Wiring Kit for LED Light Bar (2-Pin, Superseal, 12V)

Wiring kit for a single lamp for high-performance Lazer Lamps LED lights. Installation is quick, easy, and reliable with the 2-pin Superseal connection and no setup procedure required.

The kit includes:

• a 12 V relay (in a waterproof housing)
• a fuse
• a battery terminal on one end
• 1.2 m of flexible cable on the lamp wire

Additionally, it allows the use of Lazer products either in parallel with the vehicle's standard lighting, and/or via an independent switch that can be mounted inside your vehicle.

All Lazer lamps are sold with a pre-wired female connector linked to the lamp harness male connector, to facilitate wiring within your vehicle's system.

Compatible with:

Glide
Glide Elite
ST Evolution (All products)
Triple-R 750 Elite (Gen2)
Triple-R 850 Elite (Gen2)
Triple-R 1000 Elite (Gen2)
Linear-6 (Std / Elite)
Linear-12 (Std / Elite)
Linear-18 (Std / Elite)
Linear-24 Elite
Linear-36
Linear-42
Linear-48
Sentinel 7''
Sentinel 9'' Elite

Wiring kit for a single light for Lazer products (see product text for compatibility)

Cable length 1.2 m.

Includes a 12 V relay (with waterproof relay housing) and a 20 A fuse.

2-pin Superseal connections.

Relay holder certified to IP53 rating when mounted in a vertical (upright) orientation.

Includes an optional on/off switch for independent operation of the driving beams.

Braided cable sections for additional protection in the engine compartment.