The best degreaser on the market for preparing your kit for installation!
IMPORTANT: clean fairings thoroughly with a degreasing product such as K7 power clean to remove all surface impurities and grease residues.
If this step is not carried out correctly, your deco kit will not stick perfectly to the plastics and will not come off in the right place.
ATTENTION
- Do not use glass cleaners or acetone.
- New plastics are covered with release wax, so you'll need to insist on degreasing in this case.
- Degrease plastics, insisting on the ends, and dry with a clean, dry cloth.
- Place the kit at room temperature above 20°C.
- Do not use water or any other liquid for installation! We cannot guarantee that the deco kit will hold its shape with this method.
2. Easy positioning and application (figure 1) Take a piece of your Kit and visualize its location. Position the sticker on its spot to see how you're going to position it.
Slowly peel off a small part of the sticker from its paper backing.
(figure 2) This step is not necessary for the deco kits we offer!
3. Positioning (figure 1) Position the deco where you want it: the flying part of the adhesive should not be in contact with the fairing. (figure 2) Once you've found the right position, apply the flying part of the deco to keep it there.
4. Positioning (continued) (figure 1) Remove the adhesive from its paper backing (remaining part). (figure 2) Apply firm, even pressure to the adhesive, working from the middle outwards (you can use a plastic squeegee or a clean, dry cloth) to remove the air.
5. You may come across significant reliefs that will put a strain on the installation. In this case, use a hairdryer or heat gun, heat up and the deco kit will adapt perfectly to the relief.
INFO: the deco kit can be repositioned 3 minutes after installation.
Once the whole kit is in place, heat it up by sweeping with the hairdryer, applying pressure with a clean, dry cloth over the entire surface during heating and cooling, especially on sensitive areas.
The action of heat and pressure will allow the glue to set on the substrate.
Problems with air bubbles? Don't panic!
Prick the bubble at its center with a pin, hold it down and heat with the hairdryer, then remove the pin while continuing to heat.
The hot air in the bubble will leave on its own.
Many thanks to KUTVEK, our deco kit manufacturer, for helping us produce this quality item which will enable you to stick your deco kit perfectly.
