Cut-off switch RFX Race Series - OEM replica

The RFX Race Series circuit breakers are OEM replacement parts.

Complete with the same fittings, fasteners, connectors, and cable lengths as the original part.

Available for a wide variety of motorcycles.

Features:

• OEM replacement
• Accepts all original connectors
• OEM cable length

Installation instructions:

• Start by removing the front plate.
• Carefully cut the cable ties holding the start and stop switch cables on the handlebar, then unscrew the clamps and let them hang.
• Locate the switch connector on the motorcycle, it is often near the steering column on the frame but can sometimes be under the tank.
• Detach the connector and remove the switch noting the wiring path.
• Clean the connector with an electrical contact cleaner.
• Secure the new switch lightly on the handlebar in the desired position.
• Route the wires as with the old switch and assemble the connector.
• Check that the wires are not taut by turning the handlebar to full extension, adjust if necessary.
• Reinstall the cable ties if possible by positioning the cables at the back of the handlebar to avoid damage from debris.
• Put your front plate back in place.