RFX Race OEM Start Button

The buttons and switches of the RFX Race series are OEM replacement parts. They come with the same fittings, fastenings, connectors, and cable lengths as the original part.

Available for a wide range of motorcycles.

• OEM replacement
• Accepts all original connectors
• OEM cable length

Mounting instructions:

• Start by removing the front plate.
• Carefully cut the cable ties holding the start and stop switch cables to the bars, then unscrew the clamps and let them hang.
• Locate the switch connector on the motorcycle, they are often found near the steering column on the frame, but sometimes under the tank.
• Detach the connector and remove the switch, noting the wire routing.
• Clean the connector with an electrical contact cleaner.
• Secure the new switch lightly on the handlebar at the desired location.
• Route the wires as on the old switch and reconnect the connector.
• Check the freedom of movement of the wires by turning the handlebars to the full extent and making sure the wires are not too tight, adjust if necessary.
• Reposition the cable ties on the wires, placing the cables behind the bars to avoid damage from debris.
• Replace your front plate.